SEW-EURODRIVE FA37 DRS80S4 Gear Motor IP55 4Pole 400V Compact and Customizable Drive Solution for Industrial

SEW EURODRIVE FA37 DRS80S4 Reduction Motor Parameter Introduction:

Gear Unit Type: R
Indicating that the reducer belongs to the R-type series. SEW's R series reducers are typically designed to be compact and suitable for various industrial transmission scenarios. They can convert the high-speed rotation of the motor into the required low-speed high torque output to meet the working requirements of different loads.
Gear Unit Size: 17
The reducer size code "17" represents the specific specifications and size range of the reducer. Different sizes of reducers have differences in torque carrying capacity, installation dimensions, etc. This code is used for precise selection and matching of corresponding motors and loads.
Speed at 50 Hz (speed at 50Hz): 1380 r/min (it is speculated that the "106" in the original "1380 r/106 min" was written incorrectly)
When the input power frequency is 50Hz, the output speed of the deceleration motor is 1380 revolutions per minute. This is the actual output speed after deceleration by the reducer, suitable for load equipment with specific requirements for speed.
KW (power): 0.37 (0.50 hp) S1
The motor power is 0.37 kilowatts, which is approximately 0.50 horsepower when converted to British horsepower. S1 "represents continuous operation mode, which means that the deceleration motor can operate continuously at rated load and is suitable for industrial equipment that requires long-term continuous operation, such as conveyors, mixers, etc.
Voltage: 220-242/380-420V
The deceleration motor is suitable for two voltage ranges, which can be connected to a power supply of 220-242V or 380-420V. This wide voltage design enables the motor to adapt to different power supply environments, increasing its flexibility and versatility in use.
IP 55
Indicates the protection level of the motor. IP55 means that the motor has dust-proof capability (the first digit "5" represents dust-proof, although it cannot completely prevent dust from entering, the amount of dust entering will not affect the normal operation of the motor) and anti spray capability (the second digit "5" represents preventing harmful effects of water spray from all directions on the motor), suitable for harsh industrial environments.
4 POLE
Indicates that the motor is a 4-pole motor. The synchronous speed of the 4-pole motor under 50Hz power supply is 1500 revolutions per minute, combined with the output speed of 1380 revolutions per minute after deceleration mentioned above, which meets the operating characteristics of asynchronous motors and is suitable for conventional industrial drive requirements.

Overall, the SEW EURODRIVE FA37 DRS80S4 reduction motor has the characteristics of compact structure, specific speed and power output, wide voltage adaptability range, and good protection performance, making it suitable for various industrial transmission scenarios.

SEW-EURODRIVE FA37 DRS80S4 Gear Motor IP55 4Pole 400V Compact and Customizable Drive Solution for Industrial Images